If you are using DHCP, enable DHCPv6 to obtain DNC Server address to obtain Primary and Secondary DNS server addresses from DHCPv6 server.In the Static Gateway box, enter the gateway address.In the Static Prefix Length box, enter a value between 0 and 128.In the Static IP Address 1 box, enter the static IPv6 address.For the DHCPv6 server to automatically assign the IP address, gateway, and subnet mask to iDRAC, select Enabled option under Enable Auto-configuration.Select Enabled option under Enable IPv6.Else select Disabled and enter the values for: Select Enabled option under Enable DHCP to automatically assign the IP address, gateway, and subnet mask to iDRAC.Select Enabled option under Enable IPv4.Select Auto Config Domain Name to automatically acquite domain name from DHCP.These are the initial settings requirements for advanced features such as Directory services-Active Directory or LDAP, Single Sign On, and smart card. If network infrastructure has DNS server, register iDRAC on the DNS. Note, this options is disabled if Auto Negotiation is set to Enabled. Under Duplex Mode, select Half Duplex or Full Duplex option.

Note, 1000 Mbps is avaiable only if Auto Negotiation option is enabled.

Under Network Speed, select either 10 Mbps or 100 Mbps.

Note, this option is available on for dedicated mode.

Under Auto Negotiation, select On if iDRAC must automatically set the duplex mode and network speed.

Note, this option is disabled if NIC Selection is set to Dedicated. If a network fails, the traffic is routed through the failover network.

From the Failover Network drop-down menu, select one of the remaining LOMs.

LOM4 - May not be available depending on server model and network card selection.

LOM3 - May not be available depending on server model and network card selection.

Note, in blade servers, the Dedicated options is displayed as Chassis (Dedicated). This interface is not shared with the host operating system.

Dedicated - Enables the remote access device to use the dedicated network interface available on the Remote Access Controller.

Dell server idrac port